1.It adopts advanced one-time over-grinding process with four significant advantages:
2.Installation costs reduce. All equipment such as pipelines, valves, etc. are less than the recycling process
3. Reduce energy consumption Premixed tanks are smaller and energy consumption will reduce.
4.Maintenance costs reduce Due to asphalt blockage and agglomeration,the required maintenance for pre-mixed tanks has reduced.
5.Flexible adjustment of output It is easy to adjust the output without being limited by the volume of the premix tank.
6.Using a 90 kW power motor, it can meet the production of SBS modified asphalt with a polymer content of up to 6%.
7.Grinding disc clearance can be adjusted by handwheel, factory clearance setting ensures asphalt is ground and homogenized under optimal conditions.

The grinding disc material is made of high wear-resistant tool steel, which has strong wear resistance and long service life.
The mill is heated by heat-conducting oil and has a closed-type heat preservation device.
8.The working principle of the colloid mill: The core component of the mill consists of a stator and a rotor disc. During operation, under the high-speed operation of the rotor disc, the modifier will pass through the multi-stage grinding surface of the stator disc and the rotor disc in the grinding chamber. High-strength shearing and grinding between the tooth and the tooth groove, and refining and homogenizing step by step in the high-speed stirring, rough grinding, semi-finishing, fine grinding, ultra-fine grinding five-stage grinding, and then moving the disc It is driven out from the discharge port by centrifugal force, and the matrix asphalt and the polymer asphalt modifier can be uniformly refined and dispersed after one pass of shear milling.
9.The design of the moving and flat-plate flat teeth of the colloid mill is not only simple in processing, safe in use, high in running accuracy, and high in flow rate. When the polymer is subjected to extrusion shearing, the electrical energy-mechanical energy-heat energy is all completed in the same mill, which saves energy, reduces energy consumption, and achieves energy saving.

Sinoroader | Grinding System
The grinding system is the most critical part of the whole equipment. The modifier and asphalt mixture are fully sheared and the modifier is evenly dispersed in the asphalt. Two high-power colloid mills are used in series or in parallel to meet any process grinding requirements. In case of failure, it can be used alone.

Sinoroader | Rapid Heating Device
The rapid heating part uses two spiral plate heat exchangers in series to exchange heat between the asphalt and the heat transfer oil in a closed condition.It can quickly raise the asphalt by more than 50 degrees. At the same time, the pneumatic control valve and the asphalt pump speed regulation double insurance are used to adjust the asphalt heating temperature to ensure the production operation can be carried out under a very small temperature difference.

Sinoroader | Swelling Batching System
The equipment uses two swelling tanks, and the asphalt and the modifier are separately added to the swelling tank for swelling, and the two tanks are used alternately to increase the swelling time of the modifier, so that the ratio is more accurate.

Sinoroader | Modifier Metering Lifting Device
The equipment is equipped with two sets of modifier lifting devices, which transport the modifier into the swelling tank and mix with the asphalt. You can choose to operate with a hoist or a screw conveyor.

Sinoroader | Bitumen Conveying and Metering system
The high-temperature and high-viscosity volumetric metering device is adopted, and a filter is arranged in the asphalt pipeline to quantitatively transport the asphalt to the swelling tank according to the formula.
Sinoroader | Control System
The control system adopts the Siemens PLC+ industrial computer operation mode, and it can be fully automatic operation by setting several process parameters. Manual operation can also be performed with buttons to increase the reliability of the equipment and ensure the continuity of the project.